Sheet Ejection Head
We, Mitsuba can provide a variety of methods, such as a roller head method that combines a calender roll and a sheet ejection head, a sheet ejection head alone, and a circular head method that is cost-effective.
For extruders as well, we can offer optimal proposals that meet your needs, such as non-vent type, vent type, pin type, pin convert type, and gear pump combination type.
For extruders as well, we can offer optimal proposals that meet your needs, such as non-vent type, vent type, pin type, pin convert type, and gear pump combination type.
Product Features
Since the product is extruded only with the sheet ejection head, it can be introduced with a lower capital investment than the roller head method. Using a hydraulic cylinder to open and close the head makes it easy to clean inside the head when changing materials.
When changing the thickness, the die must be replaced, but by optimally designing the flow channel according to the viscosity of the rubber, it is possible to obtain accuracy comparable to that of a roller head. However, if there are several materials, it may not be possible to optimize for all rubbers. (Measuring and judging with a capillary rheometer.)
